Blogs

By The Most:

Mar 11,2022

Different Ways To Secure Cable Tracks (Cable Carriers) To Machinery

Electric wire and cables are massively used in every industry and business, be it machines or any other technical appliance. These wires are produced in bulk quantities on a regular basis, and there are many Electric Wire Supplier worldwide that supply at wholesale rates. They are of immense importance; that is why there is also a need to protect those wires from different elements like sunlight, heat, any radiation, and other wear and tear effects. Thus, cable carriers are there to guide, protect and make those wires pass through till the machines in which they are installed. These carriers sometimes also protect the hydraulic or pneumatic hoses.

Functionality Of These Carriers:

They limit the minimum bend radius of the wire and therefore bending stresses, helping the wires remain within a single plane. What they are best for is that they give a shield and protection from wear and tear, also avoid any difficulty from moving the machine from one place to the other. There is no such entanglement between the machines due to these carriers. These can only happen if the cable carrier is properly secured to machinery and can be achieved for a specific type of cable. The least should be that all the cable carriers should be securely tied at each end using a connector, mounting surface, or junction box. This should be done under the professional guidance of experts only.

Types Of Cable Carriers:

1) The drag chain version of the energy chain is the most common type. These limits bend to a single plane and are typically used in linear motion applications. This bracket usually has a special link with a flat mounting surface at both ends, including holes for fasteners. It can be screwed directly onto a flat surface. Alternatively, it can often be screwed into an angled bracket that can be mounted on a surface perpendicular to the cabling. These cables drag chains are available in standard length with end connectors on both ends or in a modular design. Modular energy chains usually consist of individual chain links that snap with plug connections. When setting up these modular cable carriers, you must specify and install the end connectors.

 

2) Longer drag chains (typically over 5 m in length) work better when running in guide troughs. This channel section provides a low friction surface that allows the cable guide to run without getting caught. The guide trough should also be firmly attached to the machine or floor. For this purpose, the feet are usually installed regularly. On the other hand, multi-flex cable carriers can be bent in all directions and are often used in multi-axis robots. This type of energy chain needs to be attached to both ends, but it often needs to be attached to some points in between. Multi-flex energy chains are usually terminated with junction boxes at both ends. The link is attached vertically with a clip at the junction box and midpoint. These clamps are located around the cable support and have legs for fixing the clamps to the surface with screws.

Popular Blogs

Get In Touch

captcha